Well, it didn’t take as long as I expected to clean up the dust spots from the two other time-lapse videos. When you’re not rendering twenty layers of transparent footage things go quite a bit faster.
Here’s the front of the turbine in close-up:
And the darker-skies version of the turbine in the landscape (which looks surprisingly similar to this one):
Finally, I accidentally shot the first time-lapse at 18 Mpixels, which is kinda huge for video work, but it gives lovely images of the detail. Here’s a sample (click to very much embiggen):
Early this morning I went out to shoot some time-lapse videos of a wind turbine I really hadn’t explored up-close, the 1.8 MW Vestas at the MWRA pumping station in Everett. It has been a while! Almost nine months since I last shot this turbine, and almost two years since I shot the Northwind 100 at the McGlynn school in Medford.
This was the first run, shorter than the others, using a neutral-density filter and a polarizer to allow me to take each frame at 1/3 second, so I could get nice blurring and tonal sweeps for the blades:
Most of the videos I shot today used the polarizer to get deep blue skies, which kinda reminded me too much of the earlier turbine videos I’d done. So I did this with the polarizer turned to keep the sky light, which gives a different effect on the blurring of the blades.
I’ve got footage for two more videos in the can, but I have to do some tweaking to remove an unfortunate dust spot that fell on the sensor during the time-lapse.
It was finally clear enough and “warm” enough, and I actually had a day off, so I went down to Ten Hills Park near Assembly Square and shot some wind turbine footage. I thought I would make a 20-layer icosacomposite of the 1.8MW turbine at the MWRA facility, but I couldn’t find a location that I was really in love with. I settled on shooting six ten-minute videos each in a different location, so I could get six 30-second icosacomposites, instead of a single 150-second icosacomposite from one location. This allowed me to scout around a bit, and figure out if there was a place I’d like to shoot the longer version.
All six videos are up on Vimeo now, in this album. I’ll post the seventh video here, which is a 720HD version of the 1080HD closeup video. This one focuses more on the hub of the turbine, while the higher-res version includes the entire length of the blades.
I went this morning to see if I could get a time-lapse movie from the location in Ten Hills Park under the commuter rail bridge, but there was barely any wind and the turbine was parked. Since I was there, I figured I get some sunrise stills:
That’ll be it on the turbine images until I get back from California.
I’m scouting out locations for a good shot of the MWRA turbine in Everett, and I shot a quick 1-hour time-lapse in Ten Hills Park near Assembly Square this afternoon. A decent video, but I think I found a better place for the next installment.
It’s weird… I thought I’d gotten the wind turbine thing over with, when I did the moonlit turbine video that went until sunrise early one December morning… but here we are again. This is a different turbine than the small Northwind 100 on the McGlynn campus. This is the 1.8 MW installation at the MWRA pumping station in Everett. Notice the MBTA Orange Line cars and commuter rail trains passing by below the turbine.
I plan to do some different angles, locations, and times in the near future, but for now, here’s how the turbine looked before I headed to New Hampshire to teach:
Here’s a new mult-layer turbine composite of the brand-new 1.8 MW turbine installed last month at the MWRA facilities in Everett, MA. Since it’s close, big, and easily filmed, I’ll probably try to do some more videos of this turbine in the future.